# Physics lab force

Calculate the Physics lab force difference between the measured mass of the cart and the experimental mass of the cart. Students can adjust the strength of the force.

The lab description pages which are linked to below describe the Question and the Purpose of each lab and provide a short description of what should be included in the student lab report. A top view of these three forces could be represented by the following diagram.

Record the slope of your graph. And to make it as easy as possible to use the labs in the classroom, much of the information is provided to teachers as PDF and Microsoft Word downloads.

Cart with no Block Set up Mount the end-stop and feet on your track, using the feet to assure the track is level. What was the magnetic field strength of the permanent magnet assembly with all six horseshoe magnets installed. Suppose the tension in both of the cables is measured to be 50 N and that the angle that each cable makes with the horizontal is known to be 30 degrees.

If that doesn't work, you may email the completed report directly to a lab TA. Picture a cart of mass M on a horizontal surface, tied to a hanging mass m over a pulley: The resultants in each of the above diagrams represent the net force acting upon the object.

What is the direction of the current, or.

Essentially, students should work efficiently and quickly to solve the Objectives, and succinctly report on their findings. If the string connected to the cart does not run parallel to the table, move the smart pulley up or down until the string is parallel.

Also calculate the percentage error of the magnitude of the graphical solution of FR compared to the analytical solution. Since the tension is constant in the string, the object with mass M and the hanging mass m have the same acceleration.

The basis of what scientists believe is the result of the careful collection and analysis of laboratory evidence. In this unit, we will examine the effect of forces acting at angles to the horizontal, such that the force has an influence in two dimensions - horizontally and vertically.

The picture is in a state of equilibrium, and thus all the forces acting upon the picture must be balanced. We would have to conclude that this low margin of experimental error reflects an experiment with excellent results.

This balancing force is called the equilibrium force and it is equal in magnitude and opposite in direction to the resultant force of F 1 and F 2. Note the difference between the values and directions of F 3 that you obtained experimentally and theoretically (using graphical and component methods).

As with all physics laboratory experiments, one must be careful to use the appropriate units. If all forces (i.e., the magnetic force and weight) are measured in newtons (), charges in coulombs (), and velocities in meters per second (), then from Equation 1 the unit of the magnetic field is given as newton per coulomb-meter per second.

A force board (or force table) is a common physics lab apparatus that has three (or more) chains or cables attached to a center ring. The chains or cables exert forces upon the center ring in.

This lab/learning activity is designed to introduce students to the idea of how direction of force relative to motion determines the future motion of the object subjected to the force.

Students can also explore the factors that determine the properties of the motion. General Physics Experiment 4. Force and Acceleration - Newton's Second Law To test the hypothesis that force is equal to the mass times the acceleration (Newton’s Second Law) To define “inertial mass” as a slope.

Equipment: Pasco Dynamics Track and Two Carts. Two Cart Accessory Weights. Click on the Record button as your lab. Physics III - 5 Pre-Lab for LAB#3 Problem 2 At a picnic, there is a contest in which hoses are used to shoot water at a beach ball from three different directions.

As a result, three forces .

Physics lab force
Rated 0/5 based on 93 review
McCulley's HTML 5 Physics Lab Simulations